Drive Model 177 Irrigation Syringe

Drive Model 177 Irrigation Syringe

Brand/Manufacturer: DRIVE MEDICAL
Hpfy stores Save

Item 0 is backorder and will be available to purchase once it is back in stock.

Drive Model 177 Irrigation Syringe is efficiently used in various E.N.T irrigation procedures. Its small, malleable tube permits deep, yet painless introduction into the external ear canal. Regulate flow by placing a finger over the small hole in the head of the instrument, if air pressure is 20 psi or under, then the stream will stop when the finger is removed. Model 177 Irrigation Syringe is used by E.N.T doctors, medical doctors, research laboratories, veterinarians.

Key Points of Drive Model 177 Irrigation Syringe:

  • Small, malleable tube
  • E.N.T irrigation procedures
  • Operated by the No 630 or a No 1 bulb

Item # Desc Pkg Price
#177 Model 177 Each

Features of Model 177 Irrigation Syringe

  • Small hole in the head, by which the flow of solution can be regulated
  • Maximum flow is obtained when this hole is covered with a finger
  • Removing finger stops solution if air-line pressure is twenty psi or less, and reduces flow if the air-line pressure exceeds twenty pounds
  • Instruction Manual

More About Drive Irrigation Syringe

To Use:


  • To secure best results, fill container no more than two-thirds full.
  • Can be operated with either compressed air or hand bulb.
  • If hand bulb is used, give taper connection a slight twist to make it hold securely.
  • Grasp the bulb firmly, using the fingers against the palm of the hand, rather than two or three fingers against the thumb.
  • The syringe is especially convenient for washing wax out of the ear. Also for general use where controlled stream is desired.
  • Large size 6-ounce bottle holds an adequate supply of liquid

To Clean:



  • Unscrew and remove syringe tube. Insert a fine wire into the back end of the tube and run it through until it reaches the forward opening.
  • The illustrations below show details of this cleaning operation.
  • Important:
    - Only a very fine wire should be used in cleaning the tube, as a strong one might push through the forward end, breaking the tip

To Sterilize:



  • Autoclave (remove the plastisol bulb and black washer).
  • Use 1 „3 bleach to 2 „3 water for not more than 10-15 minutes.
  • Cidex (2.4% glutaraldehyde solution) may also be used.
  • Be sure to follow the manufacturers directions for mixing and using these products.
  • After cleaning, be sure to rinse atomizer with warm or hot water and air dry before adding medication.
  • Disassemble the syringe by rotating the cap in a counterclockwise direction.
  • The spray tube assembly can be removed from the cap by rotating it in a counterclockwise direction.


Customer Reviews

Please enter your and your friends email address below.
Fields marked with * are compulsory

Submit Cancel
The selected product information has been successfully emailed to your friend.

Thank you for using